Chevrolet 2013 Camaro Owner's Manual page 31

Other conditions can affect the
performance of the transmitter. See
Remote Keyless Entry (RKE)
System on page 2 2.
Starting the Vehicle
To start the engine using the remote
start feature:
1. Aim the RKE transmitter at the
vehicle.
2. Press and release
3. Immediately after completing
Step 2, press and hold for at
least two seconds
turn signal lamps flash. The turn
signal lamps flashing confirms
the request to remote start the
vehicle has been received.
When the engine starts, the
parking lamps will turn on and
remain on as long as the engine
is running. The vehicle's doors
.
will be locked and the climate
control system may come on.
The engine will continue to run
for 10 minutes. Repeat the steps
for a 10-minute time extension.
Remote start can be extended
only once.
Insert the key and turn it to ON/RUN
before driving.
Extending Engine Run Time
For a 10-minute extension, repeat
Steps 1 3 while the engine is still
running. The remote start can only
be extended once.
Keys, Doors, and Windows
When the remote start is extended,
the second 10 minutes will start
immediately.
until the
For example, if the vehicle has been
running for five minutes, and
10 minutes are added, the engine
will run for a total of 15 minutes.
A maximum of two remote starts are
allowed between ignition cycles.
The vehicle's ignition switch must
be turned to ON/RUN and then back
to LOCK/OFF using the key before
the remote start procedure can be
used again.
Canceling a Remote Start
To cancel a remote start, do one of
the following:
Aim the RKE transmitter at the
vehicle and press and hold
until the parking lamps turn off.
Turn on the hazard warning
flashers.
Turn the vehicle on and then off.
2-5