Travis Industries Avalon Owner's Manual page 33

3 Follow the directions below to remove the natural gas orifices. Apply thread sealant to the LP orifices
(Rear #53, Front #56) and tighten in place with a 1/2" open end wrench. Slide the adjustable shutter
back in place over the orifice. Replace the mixing tubes and secure in place with the screws.
Remove the four screws
a
holding the front and rear
mixing tubes in place.
1/4" Nutdriver
Slide the mixing tubes away
b
from the air shutters and
place aside.
Slide both air shutters to the fully
open position (to the left - see
page 29).
d
Use a 1/2" open end wrench
to unscrew both orifices.
Front Burner
Orifice
Travis Industries
Optional Equipment
c
Apply thread sealant to the LP
orifices prior to installation. Use
the chart below to identify the
correct orifices.
1/2" Wrench
Look here for the orifice identification
Rear Burner
Orifice
9 3 5 0 8 1 2 2
Burner Orifices
Manifold
e
LP NG
#56 #46
Front
#53 #43
Rear
f
Screw the LP orifice in so the
orifice shoulder protrudes 5/16"
(indicating full insertion).
5/16"
5/16"
1 4 1 1 0 0
31