Usb Memory Connection; Connect Usb Memory; Remove Usb Memory; Ipod/Iphone Connection - Alpine CDE-136BT Owner's Manual

USB memory Connection

Connect USB memory

1
Connect the USB Extension cable to the USB connector of
the unit, and then secure the connection using the lock
case supplied with USB Extension cable as shown below.
This unit
USB connector
USB Extension cable (supplied)
2
Connect USB memory to USB Extension cable.
This unit
USB connector
USB Extension Cable (supplied)

Remove USB memory

Pull out USB memory squarely from the USB Extension
cable.
This unit
USB connector
USB Extension Cable (supplied)
Notes
• When removing USB memory, pull it out straight.
• If sound is not output or USB memory is not recognised even when USB
memory is connected, remove USB memory once, and then connect it
again.
• Change to a source other than the USB AUDIO mode, and then remove
the USB memory. If the USB memory is removed in the USB AUDIO
mode, data may be damaged.
• Route the USB cable away from other cables.

iPod/iPhone Connection

1
2
lock case
USB memory
(sold separately)

Mounting the Microphone

For the sake of safety, mount the microphone in the following location.
• In a stable and secure location.
• In a location that does not inhibit safely driving the vehicle.
• Mount the microphone in a location where the driver's voice can
Choose a location for the microphone that can easily pick up the drivers
voice. Requiring the driver to move towards the microphone for
USB memory
audibility causes a distraction that could be dangerous.
(sold separately)
Connect the USB Extension cable to USB connector as step
1 of "Connect USB memory" (refer to "Connect USB
memory" on page 43).
Connect USB cable to an iPod/iPhone with Interface cable
for iPod.
USB Extension cable (Supplied)
Interface cable for iPod (included with iPod)
easily be picked up.
43
-EN