Advertisement
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches. NOTE: It is strongly recommended this machine to be assembled by
two or more people to avoid possible injury.
STEP 1
(See Diagram 1)
A.) Slide two Ø2 ½" Round Rubber Bumpers (#43) onto the Guide Rods (#7). Insert
the two Guide Rods into the holes on the Rear Stabilizer (#8). Secure each Guide
Rod with one M10 x 1" Allen Bolt (#72) and
B.) Attach the rear of Main Base Frame (#1) to the Rear Stabilizer. Secure them with
two M10 x 2 ¾" Carriage Bolts (#62), one 4 3/8" x 2" Bracket (#20), two Ø ¾"
Washers (#77), and two M10 Aircraft Nuts (#81). Do not tighten the nuts and bolts
yet.
C.) Attach the Front Stabilizer (#19) to the Main Base Frame (#1). Secure them with
one M10 x 3" Allen Bolt (#74), one 4" x 2" Bracket (#29), two Ø ¾" Washers (#77),
and one M10 Aircraft Nut (#81) to the top hole. Secure the bottom hole with one
M10 x 2 1/2" Allen Bolt (#64) and
D.) Attach the Foot Plates (#30) to the Front Stabilizer (#19). Secure them with two
M10 x 2 ¾" Carriage Bolts (#62), Ø ¾" Washers (#77), and M10 Aircraft Nuts
(#81).
E.) Place the Vertical Frame (#2) onto the Main Base Frame. Secure them with two
M10 x 3 ½" Carriage Bolts (#63), one Pulley Bracket (#18), two Ø ¾" Washers
(#77), and two M10 Aircraft Nuts (#81). Securely tighten all nuts and bolts
previously installed.
¾" Washer (#77) from the bottom.
3/4" Washer (#77) from the back.
6
Hide quick links:
Advertisement
