Table of Contents
Advertisement
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches.
NOTE: It is strongly recommended two or more people assembling this machine to avoid
possible injury.
STEP 1
(See Diagram 1)
A.) Connect the Right and Left Upright Beams (#1 & #2) with a Cross Brace (#3) in the mid-span.
Secure each end with two M10 x 4 ¾" Carriage Bolts (#54), one 5 ½" x 2" Bracket (#46), two Ø
¾" Washers (#64), and two M10 Aircraft Nuts (#67).
B.) Attach a Weight Post (#14) to the rear diagonal support on the Left Upright Beam. Secure it
with one M10 x ¾" Allen Bolt (#59) and
onto the Weight post. Attach a Spring Clip (#48) to the Sleeve. Repeat the same procedure to
install the other side.
C.) Place the Backrest Adjustment Bar (#29) onto the selected slot on the Upright Beams.
D.) Attach the Left & Right Squat Bar Catches (#11 & #12) onto the two Upright Beams. Insert the
Right & Left Bar Catches (#7 & #8), Right & Left Safety Catches (#9 & #10) into the selected
holes on the two Upright Beams.
¾" Washer (#64). Slide an Olympic Sleeve (#44)
6
Advertisement
Table of Contents
