CDA CI921 Manual For Installation, Use And Maintenance page 13

Installation/venting
This appliance is fully compatible with
any 600mm deep kitchen units and
695 mm
complies with stringent EEC regulations.
125 mm
Your dryer is supplied with a vent hose
fig. 3
which will extend to approximately 2.4
m. We strongly recommend that this
is vented through the wall with the
attachment provided.
The position of the hole (100mm
diameter) for the vent directly behind
the tumble dryer is shown in fig.3.
If the vent through the wall is to be
positioned anywhere other than behind
the dryer, the vent hose should be
positioned at floor level and through an
adjacent side panel to an appropriate
position.
The plinth in front of the dryer must be
cut out to accommodate the air vent
grill located at the bottom front of the
tumble dyer as shown in fig. 4.
13