Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for CDA ci522
Summary of Contents for CDA ci522
- Page 1 Tumble Dryer Manual for Installation, Use and Maintenance Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer.care@cda.eu W : www.cda.eu...
- Page 2 Appliance information: Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with your appliance and to register your appliance for guarantee purposes. Appliance Model...
- Page 3 CE Declarations of Conformity: This appliance has been designed, constructed and marketed in compliance with safety requirements of EEC Directives 2006/95/EEC & 2014/35/EU (Low voltage) and requirements of EMC Directives 2004/108/EEC & 2014/30/EU. This product is manufactured to comply with the radio interference requirements of the Council directive 82/336/EEC.
-
Page 4: User Information
User Information The room must be adequately ventilated to avoid the backflow of gases into the room from appliances burning gas or any other fuels. This includes open fires. It is important to clean the lint filter after each drying cycle. Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax removers should be washed in hot water with an extra amount of... - Page 5 Do not Attempt to dry dripping wet articles. Do not Dry unwashed items in the tumble dryer. Do not Dry wool or wool mixture articles unless the article is labeled as suitable. This should avoid shrinkage. Do not Dry items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads.
- Page 6 Use and Controls Cotton Dry fig. 1 A. The timer - turn the timer knob clockwise until the required programme time around the timer knob is selected. B. Heat setting - select gentle or intensive heat recommended on the control panel. C.
- Page 7 • Select correct heat position. • Set the timer to the correct position (See programme around the timer on fascia panel). • For energy labeling purposes (EN61121:2005) for a cotton dry load, use the maximum load weight for cotton and set the timer to the recommended drying time for cotton dry as specified on the control panel.
- Page 8 To stop the machine in the middle of a programme, open the door: The drum will stop rotating automatically and reset when you close the door. To lengthen or shorten the programme, turn the timer knob. The final part of the drying cycle occurs without heat (cool down cycle) to ensure that the items will not be damaged.
-
Page 9: Care And Maintenance
Care and Maintenance Cleaning The Filter The filter is found by opening the door (fig. 2) and must always be in position when drying items in the appliance. To allow the dryer to operate efficiently fig. 2 the filter should be cleaned after each drying cycle. -
Page 10: Troubleshooting
- Check that you have not set the timer within a cool down period. If your appliance does not work, check the following points before contacting CDA Customer Care • Check that there is power to the appliance. -
Page 11: Installation
Installation Do not block the vent at the front or base of the dryer as this will impair the functioning of the appliance and could cause it to overheat. This appliance must not be installed behind a lockable fig. 3 door, a sliding door or a door with hinges on the opposite side to that of the tumble dryer. - Page 12 an open door or window. The best solution is to connect the vent hose to a permanent connection through a wall or a single glazed window. This is particularly recommended for small, cool rooms. Front venting machines must be converted to extendible rear venting before a permanent connection can be made to the outside.
-
Page 13: Reversing The Door
Reversing the Door The door on the dryer can be positioned either with the left or right hand hinging, as shown in figure fig.4. Please note: power tools must not be used when reversing the door. fig. 4... -
Page 14: Electrical Information
Electrical Information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. - Page 15 Do not shorten the supply cable, the appliance may require removing for servicing. N.B. Ensure that the plug socket is situated in an easily accessible place. If the power supply cord is damaged, it must replaced by a CDA authorised agent.
-
Page 16: Technical Information
Technical Information: Overall 85cm x 59.5cm x 58cm (height x width x dimensions : depth) Maximum dry Cotton or linen 7.0kg. weight: Maximum dry Synthetics 7.0kg. weight: Fuse rating: 13 A For electrical ratings see plate on rear of machine. Room temperature range 5˚C to 30˚C. - Page 17 NOTES:...
- Page 18 NOTES:...
- Page 19 Condensing efficiency class dry½ Sound power level 62dBA Built in/not built in Not built in E & O E. All instructions, dimensions and illustrations are provided for guidance only. CDA reserve the right to change specifications without prior notice.
- Page 20 Please contact our Customer Care Department for service on the details below. Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer.care@cda.eu W : www.cda.eu © CDA 2014...