Diagnostic Codes; Display Fault/Error Codes - Maytag NED7200TW Technical Information

Troubleshooting
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before servicing, unless
testing requires power.

Diagnostic Codes

Code Description
1 Dryer The
Thermistor Thermistor
Short Sensed resistance is
very low.
2 Thermistor The
Open Sensed Thermistor
resistance is
very high
3 Door Circuit Invalid state
Failure for more
than 256
milliseconds
Possible If either
4
motor motor
transistor transistor is
error seen open or
shorted
during startup
Stuck Key A key is
8
sensed to be
pressed
more than
75 seconds,
the key shall
be assumed
to be stuck.
Trigger Action Taken
Check for:
- Clogged lint
screen.
- Restricted vent
system.
- Check Thermistor
resistance.
Check for:
- Low ambient
temperature in
room (Below
50°F/10°C).
- Outside vent
damper is stuck
open in wintertime.
- Loose or open
wire terminals.
- Check Thermistor
resistance.
Check for:
- Loose or open
wire terminals in
Door Sense circuit.
Check for:
- Loose connections
in motor circuit.
- Run System
Check Mode and
check the motor
relay function.
- If relay functions,
disregard the
diagnostic code.
- If relay does not
function, replace
machine control
board.
Run membrane pad
check and replace
console w/membrane
pad if necessary.
WARNING
Code Description
10 No Wet
Clothes

Display Fault/Error Codes

Display Description
tS Dryer
Thermistor
Short Sensed
do Door Open
FE Power source
frequency
Error
dC Door Circuit
Failure
Heating Error Invalid
hE
5
Trigger Action Taken
Sensor bar Check for:
detects no wet - Running dryer with
clothes while a no wet clothes in
Sensor Dry sensor dry cycle
Cycle
Trigger Action Taken
The Check for:
Thermistor - Clogged lint
resistance is screen.
very low. - Restricted vent
system.
- Check Thermistor
resistance.
- Check for
diagnostic code 1
Running the Check for:
dryer with - Close the door,
door open and run the dryer
- Loose or open
wire terminals in
Door Sense
circuit.
- Check for
diagnostic code 3
Invalid power Check for:
source - Not using regular
Frequency power source
frequency
- Invalid power
frequency sense
circuit
Invalid state Check for:
for more than - Loose or open
256 wire terminals in
milliseconds Door Sense
circuit.
- Check for
diagnostic code 3
Check for:
heating
- Restricted vent
temperature
system.
in running the
- Check
dryer
Thermistor
resistance.
W10162408