System Operation
Removing a Tape from the VCR
Viewing Images
Rev 1.01
To remove a tape from the VCR:
1.
Unlock and open the access panel on the front of the VCR enclosure.
2.
If the vehicle is switched off, press the POWER button on the front panel. This
provides temporary power to the VCR so that the tape can be removed.
3.
Press the STOP/EJECT button on the front panel once to stop recording. Press the
button a second time to eject the tape.
To view images in the vehicle:
1.
Unlock and open the access panel on the front of the VCR enclosure.
2.
Plug a monitor cable into the AUDIO/VIDEO output on the front panel of the VCR.
3.
Plug the other cable end into the AUDIO/VIDEO IN connector on the back of a 12 VDC
or battery powered audio/video monitor.
4.
Start the vehicle or press the POWER button for temporary power. The camera light
starts flashing and the VCR automatically starts recording after 10 seconds.
Temporary power puts the VCR into Record mode.
5.
Press the STOP button if the VCR is recording.
6.
Press the REW (rewind) or FF (fast forward) button to search the tape for the desired
image(s).
7.
Press the PLAY button to play back the tape.
WARNING!
Do not leave a tape in the VCR if storing the unit for extended
periods.
26
Document 900.0341
12/05