Table of Contents
Advertisement
System Setup
Initial Setup
Rev 1.01
3.
Start the vehicle. The VCR automatically starts recording after approximately 10
seconds, subject to Record Delay and Timer settings. You should see the
alphanumeric display superimposed on the video image from the camera.
4.
Press the STOP button once to stop the VCR recording. OR press and hold for three
seconds to enter Program mode.
For a short programming session, you may press the POWER button (temporary
power feature) to avoid starting the vehicle.
Note
You can program the VCR when no video camera is connected to the system.
In this case the message NO VIDEO DETECTED displays on the screen.
Figure 3-2
Welcome Screen
Honeywell
HTR62
Mobile Video Recorder
Firmware Ver 02.00
Honeywell Video Systems
For Technical Support
Call 1-800-796-2288
The HTR62 comes pre-configured from the factory with the default settings shown in
Figure
3-3. You can change the settings shown in
Table 3-2
System Default Settings
Setting
Title line
Date and time, Daylight
Saving Time
Signal indicators (T1 to T5)
Start Delay (SDLY)
Recording speed (EP/SP)
Table
3-2.
To program, see section ...
Line
1,
page 18
Line
2,
page 18
Lines 3 and
4, page
19
SDLY Start
Delay, page
Lines 5 and
6, page
20
16
20
Document 900.0341
12/05
Advertisement
Table of Contents
