After Use - NEC VT800 User Manual

 After Use

preparaton: Make sure that the main power is turned off.
1. Unplug the power cable.
2. Disconnect any other cables.
3. Retract adjustable tilt feet if extended.
4. Cover the lens with the lens cap.
5. Put the projector and accessories in the supplied soft case.
Place the projector in the soft case with the lens facing upward as shown below. this is to prevent the lens from
damage.
insert the projector with
the lens facing upward
NOTE: When placing the projector in the soft case, retract the tilt foot and the rear feet. Failure to do so may case damage to the
projector.
CAUTION:
Use caution when putting the projector in the soft case immediately after the projector has been operating. The pro-
jector cabinet is hot.
3. Projecting an Image (Basic Operation)
0