Terminal Panel Features - NEC VT800 User Manual

Terminal Panel Features

10
( )
USB LAN
The actual appearance of the terminal panel may differ slightly from that shown in the drawing, but this does not af-
fect the projector's performance.
1. COmpUTER 1 IN/COmpONENT 1 IN Connector
(mn D-Sub 15 pn) (→page 11, 1, 15)
AUDIO IN (Stereo mn Jack) (→page 11, 1, 15)
. COmpUTER  IN/COmpONENT  IN Connector
(mn D-Sub 15 pn) (→page 11, 15)
AUDIO IN (Stereo mn Jack) (→page 11)
. hDmI IN (19 pn hDmI Type A) (→page 1, 14)
4. S-VIDEO IN Connector (mn DIN 4 pn) (→page
1)
AUDIO L/mONO, R (RCA) (→page 1)
5. VIDEO IN Connector (RCA) (→page 1)
AUDIO L/mONO, R (RCA) (→page 1)
. mONITOR OUT Connector (mn D-Sub 15 pn)
(→page 1)
AUDIO OUT (Stereo mn Jack) (→page 1)
4
8 9
LAN
USB
COMPUTER /
COMPONENT 1 IN
S-VIDEO IN AUDIO IN
MONITOR OUT
L/MONO R
VIDEO IN AUDIO IN
L/MONO R
5
1
COMPUTER /
AUDIO IN COMPONENT 2 IN
AUDIO OUT PC CONTROL
6 7
7. pC CONTROL port (D-Sub 9 pn) (→page 10, 11)
Use this port to connect your PC or control system
to control your projector via a serial cable. This
enables you to control the projector using serial
communication protocol. A commercially available
RS232C cross cable is required to use this port.
You can also control the projector by using PC Con-
trol Utility 3.0 (downloadable from our website:http:
www.nec-pj.com). To do so you must first have PC
Control Utility 3.0 installed on your PC. If you are
writing your own program, typical PC control codes
are on page 10.
8. USb port (Type A) (→page )
9. LAN port (RJ-45) (→page 18, 98)
7
1. Introduction
3
HDMI IN
AUDIO IN
2