Car Seat/Stroller Assembly; Opening Stroller; Front Wheel Assembly; Lock Footrest - Century 4 in 1System Pro Sport Plus Instruction Manual

CAR SEAT/STROLLER ASSEMBLY

Stroller Right
Side

Opening Stroller:

1
Stand stroller upright and pull tab
up to release latch.
2
Spread handle and rear legs until
both fold locks "click" into position.

Front Wheel Assembly:

1
Hold swivel wheel assembly upright
(tab pointing down).
2
Tilt stroller slightly back and push
wheel assembly up onto leg until it
locks in place.
Repeat steps 1 & 2 for opposite leg.
.
CAUTION: After wheel
3
assembly is complete, pull on
wheels to check that they are
locked into place.
Stroller Left
Side
Tab

Lock Footrest:

1
Push footrest down so that frame
tube is centered between three
(3) tabs on bottom of footrest
and snaps into place.

Rear Wheel Assembly:

1
Remove axle protectors from ends of axle and discard.
2
Rotate brake lever to the unlocked
position and slide wheel onto each
end of axle rod with brake ribs
facing in.
Brake Ribs
3
Attach wheel to axle:
• Snap wheel retainer onto grooved end of axle. Make sure
large end of wheel retainer is towards wheel.
• Snap wheel retainer cap over wheel retainer.
Hub
Retainer
Wheel
Cap
Cap
Retainer
CAUTION:
- Failure to install retainer cap may cause wheels to
come off of stroller.
- After wheel assembly is complete, pull on wheels
to check that they are locked into place.
• Line up hub cap tabs with slots in wheel and snap hub
cap into place.
WARNING
Prevent possible choking hazard: discard axle
protectors and polybag which contained rear wheel
parts.
Tabs
Brake Lever
Wheel