Everlast EVE-890 Owner's Manual page 7

STEP 2 (See Diagram 2)
A.) Slide both a Rubber Bumper (#26) and Safety Stop (#6) onto a Guide Rod (#5).
B.) Slide a Sliding Bar Catch (#8) onto the Guide Rod.
C.) Insert the bottom of the Guide Rod into the ring cap on the left Stabilizer. Insert the top
of Guide Rod into the ring cap on top of the left Upright Beam. Use the two M8 x ½"
Allen Screws (#16) on the caps to secure the Guide Rod.
D.) Attach a Safety Hook (#7) to the bracket on the Safety Stop. Secure it with one M10 x 1
5/8" Allen Bolt (#20), two Ø ¾" Washers (#14), and one M10 Aircraft Nut (#17).
E.) Attach the Safety Hook to the selected hole on the Upright Beam to obtain the desired
height for safety catch.
F.) Repeat Steps A, B, C, D and E above to install the other side.
G.) Securely tighten all nuts and bolts previously installed.
6
DIAGRAM 2