Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for CDA FWV160
Summary of Contents for CDA FWV160
- Page 1 Manual for Installation, Use and Maintenance Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...
- Page 2 Do not let the mains cord hang over the edge of the table or worktop on which the appliance stands. Appliance information: Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with your appliance and to register your appliance for guarantee purposes.
-
Page 3: Before First Use
Before first use It is recommended that you remove all internal and external packaging and clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda and warm water and then thoroughly dry the interior. The appliance may have an odour to it at first use. - Page 4 Use and Controls To switch the power on/off • Touch and hold the power button. To change the temperature • Press the up or down buttons until the required temperature is as shown on the display. Optimal temperature selection Whilst wine is best stored at temperatures between 13 and 15˚ C, your wine can also be stored at drinking temperature.
-
Page 5: Care And Cleaning
Care and Cleaning Always disconnect the appliance from the mains electrical supply before any cleaning or maintenance. • Do not use abrasive products or detergents. After washing, rinse and dry thoroughly. • The exterior of the appliance and the seal should be cleaned using mild soapy water and dried thoroughly. The interior should be cleaned using a solution of bicarbonate of soda and lukewarm water. -
Page 6: Troubleshooting
Troubleshooting If you have any problems with your appliance, you should check the troubleshooting guide prior to calling CDA Customer Care to prevent unnecessary service calls and potential cost. If the appliance is not working, check • There is power to the appliance •... -
Page 7: Installation
Installation This appliance should be installed in a well ventilated, dry room. 51.4 This appliance must not be installed: 1. In direct sunlight 479.6 2. Adjacent to a heat source (oven or radiator) 3. Below a hob unit This appliance is intended to be built in to a standard kitchen under counter drawer unit. - Page 8 Mounting the fascia 6. Open the drawer and remove the screws located on either side, as shown in figure 5, to allow the drawer to be removed completely. 7. Locate the fascia panel on the front of the appliance and secure with four screws, as shown in figure 6, ensuring that it aligns with adjacent fascia panels and that the lower edge of the fascia panel aligns with the lower edge of the drawer front (for 140mm fascia...
-
Page 9: Mains Electricity Connection
Mains Electricity Connection THIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY DOUBLE POLE SWITCHED BY A COMPETENT PERSON, USING FIXED WIRING VIA A DOUBLE FUSE SPUR OUTLET POLE SWITCHED FUSE SPUR OUTLET AND PROTECTED BY A 3A FUSE. We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. - Page 12 Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...