Advertisement
5) Loosen nut (A) fig.15 and turn set screw (B) counterclockwise two or
three times.
6) Loosen lock knob (A) Fig.16, and move the jig (C) until the vertical work
support plate (D) is against the saw blade and tighten knob (A).
7) Verify if the vertical work support plate (D) fig.16, is parallel with the
saw blade.
8) If an adjustment is necessary, loosen lock knob (A) fig.16, and rotate
micro knob (E) clockwise as far as possible to align the holes (F) with
the guide bar (G) and gain access to the round hd allen screws. Loosen
the two round hd allen screws inside the holes (F) and move jig (C) until
the vertical work support plate (D) is parallel with the saw blade. Then
tighten the two round hd allen screws inside the holes (F).
9) Move jig (C) fig.16, 1/8" away from the blade so that the vertical work
support plate (D) clears the saw blade, tighten lock knob (A).
10) Turn set screw (A) fig.17 clockwise until it bottoms. This prevents the
vertical work support plate (B) from accidentally being moved into the
blade, tighten nut (C).
11) Loosen set screw (A) fig.18 and adjust the pointer (B) to the "0" mark
on the scale.
ADJUSTMENTS
FIGURE 15
FIGURE 16
FIGURE 17
FIGURE 18
Advertisement
