Related Manuals for King Canada K-1501
Summary of Contents for King Canada K-1501
-
Page 1: Instruction Manual
TENONING JIG MODEL: K-1501 INSTRUCTION MANUAL COPYRIGHT © 2006 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC. - Page 2 Warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence or accidents, repairs or alterations and lack of maintenance. KING CANADA shall in no event be liable for death, injuries to persons or property or for incidental, special or consequential damages arising from the use of our products.
-
Page 3: General Safety Instructions
GENERAL SAFETY INSTRUCTIONS 1. KNOW YOUR TOOL eyeglasses only have impact resistant lenses, they are NOT safety glasses. Also use a face or dust mask if cutting Read and understand the owners manual and labels affixed to operation is dusty. the tool. - Page 4 ASSEMBLY 1) Fasten clamp arm (A) Fig.2 to the back of the work support plate using 2 cap screws (B) and lock washers as shown. FIGURE 2 2) Fasten clamp assembly (A) Fig.3 to the clamp arm (B) using the special bolt (C) as shown.
- Page 5 ASSEMBLY 7) Lift jig assembly off the base (B). Loosen and remove the two round hd allen screws and washers (C) from the base. FIGURE 7 8) Slide base (A) Fig.8 until the two holes (B) are aligned with the holes in the guide bar (C).
- Page 6 ADJUSTMENTS ADJUSTING T-SLOT GUIDE BAR TO TABLE SLOT Make sure the saw is disconnected from the power source before proceeding! A bonus T-slot guide bar has been included with this Tenoning Jig to offer a more versatile product which fits most table saws on the market. This bonus T-slot guide bar generally fits on portable builders table saws having a T-slot 1/4”...
- Page 7 ADJUSTMENTS 5) Loosen nut (A) fig.15 and turn set screw (B) counterclockwise two or three times. 6) Loosen lock knob (A) Fig.16, and move the jig (C) until the vertical work support plate (D) is against the saw blade and tighten knob (A). FIGURE 15 7) Verify if the vertical work support plate (D) fig.16, is parallel with the saw blade.
- Page 8 ADJUSTMENTS ADJUSTMENTS 1) For rapid adjustment of the vertical work support plate (A) fig.19, toward or away from the saw blade, loosen knob (B), press down on the quick release (C) and move jig (D) as necessary. Release quick release and tighten knob (B) after rapid adjustment is made. 2) Fine adjustment of the vertical work support plate (A) fig.19, can be accomplished by loosening the knob (B) and rotating the micro knob (E) until the plate (A) is at the desired position.