Advertisement
1. KNOW YOUR TOOL
Read and understand the owners manual and labels affixed to
the tool. Learn its application and limitations as well as its
specific potential hazards.
2. REMOVE ADJUSTING KEYS AND WRENCHES.
Form habit of checking to see that keys and adjusting
wrenches are removed from tool before using or turning it on.
3. KEEP CHILDREN AWAY.
All visitors should be kept a safe distance from work area.
4. MAKE WORKSHOP CHILD-PROOF.
Use padlocks, master switches or remove starter keys.
5. WEAR PROPER APPAREL.
Do not wear loose clothing, gloves, neckties or jewelry (rings,
watch) because they could get caught in moving parts. Non-
slip footwear is recommended. Wear protective hair covering
to contain long hair. Roll up long sleeves above the elbows.
6. ALWAYS WEAR SAFETY GLASSES.
Always wear safety glasses (ANSI Z87.1). Everyday
Unpack the contents of the Tenoning Jig box and all the
loose parts. The illustration to the right shows all the items
supplied with the Tenoning Jig. Compare them to the list
below.
1- Jig assembly, 3/8" x 3/4" T-slot bar and
vertical work support assembly
2- Clamp assembly
3- Special Bolt
4- Clamp arm
5- Lockwashers (2)
6- Cap screws (2)
7- 1/4" x 3/4" T-slot bar
8- Washers (2)
9- Round hd allen screws (2)
10- Rubber handles (2)
11- 8mm Hex. key
12- 4mm Hex. key
13- 3mm Hex. key
14- 2.5mm Hex. key
Not shown- Instruction manual
GENERAL SAFETY INSTRUCTIONS
UNPACKING
eyeglasses only have impact resistant lenses, they are NOT
safety glasses. Also use a face or dust mask if cutting
operation is dusty.
7. DON'T OVERREACH.
Keep proper footing and balance at all times.
8. MAINTAIN TOOL WITH CARE.
Keep tools sharp and clean for best and safest performance.
Follow instructions for lubricating and changing accessories.
9. DISCONNECT TOOLS.
Before servicing, when changing accessories or attachments.
10. CHECK DAMAGED PARTS.
Before further use of the tool, a guard or other parts that are
damaged should be carefully checked to ensure that they will
operate properly and perform their intended function. Check for
alignment of moving parts, breakage of parts, mounting, and
any other conditions that may affect its operation. A guard or
other parts that are damaged should be properly repaired or
replaced.
FIGURE 1
Advertisement
