Advertisement
7) Lift jig assembly off the base (B). Loosen and remove the two round hd
allen screws and washers (C) from the base.
8) Slide base (A) Fig.8 until the two holes (B) are aligned with the holes
in the guide bar (C). Fasten base to guide bar with the two round hd
allen screws and washers (D) as shown in Fig.9.
9) Reassemble parts which were removed in Steps 4, 5 and 6 in reverse
order. Fig.10 illustrates the Tenoning Jig reassembled for operation on
a left tilting arbor saw.
ASSEMBLY
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 10
Advertisement
