Advertisement
1) Fasten clamp arm (A) Fig.2 to the back of the work support plate using
2 cap screws (B) and lock washers as shown.
2) Fasten clamp assembly (A) Fig.3 to the clamp arm (B) using the
special bolt (C) as shown.
3) Fasten handles (D) Fig.3 to the jig assembly (E) as shown.
4) IMPORTANT: The installed 3/8" x 3/4" T-slot guide bar (F) Fig.3,
located on the base (G) of the Tenoning Jig, has been preset at the
factory for operation on right tilting arbor table saws. If you wish to use
on a portable builders table saw, the T-slot guide bar must be replaced
with the 1/4" x 3/4" T-slot guide bar. If you are using the Tenoning Jig
on a right tilting arbor saw, proceed with instructions for "Aligning
Tenoning Jig". If you are using the Tenoning Jig on a left tilting arbor
saw, the guide bar (F) Fig.3, must be relocated on the base (G) of the
Tenoning Jig, as follows:
FOR LEFT TILTING ARBOR SAWS ONLY
5) Loosen and remove the large lock knob and flat washer (A) Fig.4 from
the Tenoning Jig.
6) Using a 3mm hex. key, loosen set screw (A) Fig.5 and remove the
micro-adjustment assembly (B) from the Tenoning Jig by pressing
down on the quick release (C). Fig.6 shows the micro-adjustment
assembly removed.
FIGURE 5
ASSEMBLY
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 6
Advertisement
