Whirlpool ACM816BA Instructions For Use Manual page 11

The Flexi cook function is also able to detect when a pot is moved from one zone to the other one within the flexi cook area keeping the same power level of the zone
where the pan originally was placed (see the example in the figure below: if the pot is moved from the front heater to the rear heater, the power level will be shown
on the display corresponding to the zone where the pot is placed).
It is also possible to operate the Flexi cook area as two independent cooking zones, using the corresponding button of the single zone. Place the pot in the center of the
single zone and adjust the power level with the slide touchscreen.
i
Important: make sure to place the pans centered on the cooking zone in the way to cover the logo
In case of big pot, oval, rectangular and elongated pans make sure to place the pans centered on the cooking zone covering both
Examples of good pot placement and bad pot placement :
CLEANING
WARNING
IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.
• After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.
• Sugar or foods with a high sugar content damage the hob and must be immediately removed.
• Salt, sugar and sand could scratch the glass surface.
• Use a soft cloth, absorbent kitchen paper or a specific hob cleaner (follow the Manufacturer's instructions).
- Do not use steam cleaners.
- Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator ("H")
is not displayed.
GB18
placed in the center of the single cooking zone.
logos.