Advertisement
DIMENSIONS
- COOKTOP/HOB CUTOUT DIMENSIONS
Minimum Clearance
(below benchtop)
CT560X
70mm
CT2802
CT560C
70mm
CT6551S
CT5602F
70mm
BICT602
COOKTOP/HOB DIMENSIONS
Model
Width
Depth
(side to side)
(front to back)
CT560X
578mm
511mm
CT560C
578mm
511mm
CT5602F
578mm
511mm
CT2802
289mm
511mm
CT6551S
(Cooktop)
578mm
511mm
(Controls)
88mm
511mm
BICT602
578mm
511mm
Power Supply:
CT560X, CT560C, CT5602F, CT6551S = 5.9kW @ 220-240V (25A)
CT2802 = 3.0kW @ 220-240V (12.8A)
IMPORTANT: When installing the CT2802, the power supply cord
must be rated for use at 100
C.
0
CT6551S CONTROL BOX INSTALLATION
Remove the brackets from the cooktop/hob and the control box.
Place the cooktop/hob in the cutout.
60mm
Feed the cooktop/hob wiring harness up through the
65mm
control box cutout.
55mm
Remove control box cover.
Connect the cooktop wiring harness lining the numbers/letters
on the harness with the numbers/letters on the control box
connector block.
control box connector block
plastic wiring card
Height
(below benchtop)
Leave plastic wiring card attached for future reference.
Clamp the wiring harness.
60mm
Wire the mains to the control box and clamp.
60mm
Replace control box cover.
60mm
55mm
Roll the control box into the cutout.
Secure control box and cooktop/hob using brackets provided.
45mm
63mm
Note: Two small brackets are provided that screw to the sides of
45mm
the control box. These must be used to clamp the control box down
to the benchtop. Three brackets are provided for clamping down the
cooktop/hob.
CLAMPING DOWN COOKTOP/HOB
Place the cooktop/hob into the cutout and tighten with the supplied
clamps. These will cope with bench thickness 20-50mm.
INSTALLATION CHECKLIST
Please check through the list provided to ensure correct installation.
Is the product earthed?
Check that the power cable is NOT touching the product. This will
ensure that the cable is not damaged by heat from the product.
Is the product clamped down securely?
Operation Checklist
Check for correct function of the product by switching on all
elements and leaving on for at least 1 minute.
Are all 'On' lights/neons functioning?
Are all elements glowing?
To check for correct function of the 'Surface Hot' lights/neons,
switch off all elements. Are all 'Surface Hot' lights/neons
functioning?
Advertisement
