Image Q400 IMTL39906.0 User Manual page 9

8. Hold the Console Base (47) near the Left Handrail (71).
Attach the end of the ground wire to the indicated small
hole in the Left Handrail with the Silver Ground Screw
(75).
9. Touch the Right Handrail (72) to discharge any static.
Slide the sleeve off the connector on the Upright Wire
(42) as shown in the inset drawing. Next, press the end of
the Upright Wire into the socket in the bottom of the
Console Base (47). The connector should slide easily
into the socket and snap into place. If the connector
does not slide easily and snap into place, turn the connec-
tor and then insert it. Then, slide the sleeve back over the
connector.
10.Set the Console Base (47) on the Handrails (71, 72).
Attach the Console Base with four 3/4" Screws (2). Start
all four Screws before tightening them; do not over-
tighten the Screws.
See the lower drawing. Make sure that the Upright
Wire (42) is routed below the two indicated round
posts (A). Next, press the Upright Wire into the slot be-
tween the square post (B) and the Console Base (47).
8
Small
Hole
71
9
72
Sleeve
42
10
72
2
A
42
9
Ground
Wire
47
75
42
Connector
47
B
47
47
71
2