Wlan Settings; Advanced Wlan Settings - Nokia E75 User Manual

To define the packet data settings, select
connection and When available
device to the packet data network when you switch the
device on in a supported network, or
register the device to a packet data network only when
an application or action attempts to establish a packet
data connection. This setting affects all access points
for packet data connections. To use the device as a
packet data modem for your computer, select
point, and enter the access point name provided by
your service provider. To use a high-speed data
connection, select High speed packet access
Enabled.

WLAN settings

SelectMenu Control panel
>
Connection Wireless
>
To have an indicator displayed when there is a wireless
LAN (WLAN) available in your current location, select
Show WLAN availability
To select the interval for your device to scan for
available WLANs, and to update the indicator, select
Scan for networks. This setting is not available unless
you select Show WLAN availability
To set the device to test the internet capability of the
selected WLAN automatically, to ask for permission
every time, or to never perform the connectivity test,
select Internet connectivity test
automatically, Ask every
select Run automatically
performed when the device asks for it, and the
Packet data
to register the
When needed
Access
>
Settings and
>
LAN.
> Yes.
> Yes.
Run
>
time, or Never run. If you
or allow the test to be
connectivity test is performed successfully, the access
point is saved to internet destinations.
To check the unique media access control (MAC)
to
address that identifies your device, enter
*#62209526# in the home screen. The MAC address is
displayed.

Advanced WLAN settings

Select Options Advanced
>
WLAN settings are normally defined automatically, and
changing them is not recommended.
To edit the settings manually, select
configuration > Disabled, and define the following:
Long retry limit
•
transmission attempts if the device does not receive
a receiving acknowledgement signal from the
network.
Short retry limit
•
transmission attempts if the device does not receive
a clear-to-send signal from the network.
RTS threshold — Select the data packet size at
•
which the WLAN access point device issues a request
to send before sending the packet.
TX power level
•
device when sending data.
Radio measurements
•
radio measurements.
Power saving — Select whether to use the WLAN
•
power saving mechanism to save the power in the
device battery. Using the power saving mechanism
enhances the battery performance but may weaken
WLAN interoperability.
settings. The advanced
Automatic
— Enter the maximum number of
— Enter the maximum number of
— Select the power level of your
— Enable or disable the
157