3.3.7 Removing the power transformer
(See Figs.13 and 14)
• Remove the rear panel.
• Remove the amplifier assembly.
• Remove the speaker terminal board.
(1) Remove the tie band bundling the power cord and power
transformer wire. (See Fig.13.)
(2) Disconnect the wire from the connector
mother board. (See Fig.13.)
(3) Remove the five screws L attaching the mother board.
(See Fig.13.)
(4) Take out the mother board together the heat sink.
(5) Remove the four screws M attaching the power transform-
er. (See Fig.14.)
(6) Take out the power transformer from the rear chassis.
Mother board
CN151
on the
Tie band
CN151
L
Power cord
Power transformer wire
Fig.13
Rear chassis
M
Power transformer
Fig.14
Heat sink
L
M
(No.MB075)1-31