If An Indicator Turns On - Panasonic PT-EX600U Service Manual

Troubleshooting

If an indicator turns on

If a problem occurs within the projector, it will be notified with the temperature indicator <TEMP>, the filter
indicator <FILTER>, the shutter indicator <SHUTTER>*, and the lamp indicator <LAMP>.
Check the status of the indicators and take the following action.
CAUTION
ò Before you take a remedial measure, Turning off the projector.
ò If multiple indicators light or blink, verify the status of the projector by looking at each indicator.
Note
ò Confirm the status of the power indicated on the <ON(G)/STANDBY(R)> indicator.
When operating correctly
„
The status of the indicator is displayed with the following symbols.
Off On Flashing
p ò
: , : , :
★
<ON(G)/
<TEMP>
STANDBY(R)>
Green/Red/
Red
Orange
p/p/p p
¢* 1
p/ò/p
¢* 1
ò/p/p
p/p/★* 2 ¢* 1
★* 2 /p/p ¢* 1
p/p/★* 2 ¢* 1
¢* 1
ò/p/p
¢* 1
p/ò/p
2 ¢* 1
/
p p/ ★*
*1: The indicator will change according to different conditions, regardless of the status of other indicators.
*2: The indicator will flash in approximately 1-second intervals.
Off or On or Flashing
¢
, :
Indicators
<SHUTTER>
<FILTER>
Orange
Blue
p p
¢* 1 ¢* 1
¢* 1 ¢* 1
¢* 1 ¢* 1
¢* 1 ¢* 1
¢* 1 ¢* 1
¢* 1
ò
¢* 1 ★* 2
¢* 1 ★* 2
Status of the projector
<LAMP>
Orange
The power plug has been removed from the out-
p
let.
The projector is in the standby mode.
Turns on when pressing the <POWER ON> but-
¢* 1
ton on the remote control or the <
the side control.
¢* 1
The projector is operating normally.
The lamp is cooling down. The projector does not
turn on when pressing the <POWER ON> button
¢* 1
on the remote control or the <
side control until the standby indicator <ON(G)/
STANDBY(R)> changes to red.
The projector is in the power management mode.
¢* 1
The lamp will turn on when controlling the projec-
tor, allowing the user to start operating it.
Power management mode is [On] and the lamp is
¢* 1
cooling down.
The shutter function has been turned on.
¢* 1
Press any button on the remote control or the side
control to cancel the function.
The projector is in the shutter management mode.
¢* 1
The lamp will turn on when controlling the projec-
tor, allowing the user to start operating it.
Shutter management mode is [On] and the lamp
¢* 1
is cooling down.
-94-
> button on
> button on the