Genelec 8010A Operating Manual
  1. Manuals
  2. Brands
  3. Genelec Manuals
  4. Speakers
  5. 8010A
  6. Operating manual

Genelec 8010A Operating Manual

Hide thumbs Also See for 8010A:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

See also: Operating Manual
8010A
Operating Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 8010A and is the answer not in the manual?

Questions and answers

Related Manuals for Genelec 8010A

Summary of Contents for Genelec 8010A

  • Page 1 8010A Operating Manual...

  • Page 2: General Description

    A minimum clearance of 2.5 centimeters (1 in) Packing contents behind, above and on sides of the monitor must be Each 8010A is supplied with a mains cable and found. The space adjacent to the amplifier must ei- this operating manual.

  • Page 3: Input Connector

    XLR SIGNAL MAINS INPUT MAINS 50 / 60 Hz 30 W 100 - 240 V~ INPUT CONNECTOR 8010A BI-AMPLIFIED MONITORING SYSTEM CONNECTOR MADE IN FINLAND www.genelec.com Figure 3. Control and connector layout on the rear panel of a 8010A. 2 English...

  • Page 4: Tone Controls

    Table 1: Suggested tone control settings for various acoustical environments Autostart function Tone controls The signal sensing Autostart function of the 8010A The frequency response of the Genelec 8010A powers it up when playback begins. Automatic can be adjusted to match the acoustic environ-...

  • Page 5: Mounting Options

    This equipment generates, uses and can radiate radio frequency energy and, if not unit. Any maintenance or repair of the 8010A should installed and used in accordance with the instructions, may cause harmful interfer- only be done by qualified service personnel.
  • Page 6 (dBr) vs freq (Hz) 10 Jan 13 Figure 5. The upper cur ve group shows 0° the horizontal directiv- ity characteristics of the 15° 8010A measured at 1 m. 30° The lower curve shows 45° the system's power re- 60° sponse.

  • Page 7: System Specifications

    sysTEM spECiFiCATions CrossovEr sECTion Lower cut-off frequency, –6 dB: < 67 Hz Input connector: XLR female 7 kOhm: pin 1 gnd, pin 2 + Upper cut-off frequency, –6 dB: > 25 kHz pin 3 - Free field frequency response (± 2.5 dB): 74 Hz–20 kHz Input level for 100 dB SPL output at 1 m: -6 dBu...
  • Page 8 Jianwai SOHO, Building 12, Room 2605 D-1504, Chaoyang District Beijing 100022, China Phone +86 10 8580 2180 Fax +86 10 8580 2181 Email genelec.china@genelec.com www.genelec.com Genelec Document D0117R001 Copyright Genelec Oy 1.2014. All data subject to change without prior notice.

Table of Contents

Save PDF