Log Placement - White Mountain VFP24FP2 Series Installation Instructions And Owner's Manual

Before you begin: Do not, handle these logs with your bare hands!
Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation
of this heater. Sooting and other problems may result if the logs are
not properly and firmly positioned in the appliance.
WARNING: Failure to position the parts in accordance with this
diagram or failure to use only parts specifically approved with
this appliance may result in property damage or personal injury.
PROPER INSTALLATION SEQUENCE:
1. Place back log (#1) between rear log support and burner pan.
2. Place left, front log (#2) onto the two left, front pins on the burner
pan.
3. Place right, front log (#3) onto the two right, front pins on burner
pan.
5. Apply Glowing Embers as shown in the image below. Note:
Application of excess Glowing Embers may adversely affect
performance of the fireplace.
WARNING: All previously applied Glowing Embers must be
removed prior to reapplication.
Glowing Ember Placement
30411-9-0714

LOG PLACEMENT

2
NUMBER
Note: Replacement Glowing Embers must be purchased from an
authorized distributor.
Attention: When ordering parts, it is very important that part num-
ber and description of part coincide.
USE ONLY MANUFACTURER'S REPLACEMENT PARTS. USE
OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH.
The following WARNING applies when log set is installed onto an
unvented gas burner assembly.
WARNING: This appliance is equipped for natural or propane
gas. Field conversion is not permitted.
1
Log Placement
INDEX PART DESCRIPTION
NUMBER
1 R-7506 BACK LOG
2 R-7504 LEFT FRONT LOG
3 R-7505 RIGHT FRONT LOG
Completed Log Assembly
3
Page 17