Connecting The Touch Display; Multimedia Features; Testing The C4267Pw Multi-Touch Chassis Display - 3M Multi-Touch C4267PW User Manual

14

Connecting the Touch Display

Note: You are cautioned that any change or modification to the equipment not expressly
approved by the party responsible for compliance could void your warranty.
To connect the Multi-Touch Chassis Display:
1. Turn off your computer. You should always turn off the computer before connecting
or disconnecting a device.
AC
Input
Power
Switch
2. Select the appropriate video cable: Display Port, HDMI, DVI, or VGA. Connect one
end of the video cable to the video connector on the display. Connect the other end to
the video card in your computer.
3. Connect one end of the USB touch sensor cable to the LCD. Connect the other end to
an available port on your computer.
4. Connect the power cable to an appropriate grounded power source.

Multimedia Features

The C4267PW Multi-Touch Chassis Display comes with speakers built into the back of
the display housing and includes audio cables. These cables can be connected underneath
the display.

Testing the C4267PW Multi-Touch Chassis Display

Note: The C4267PW Multi-Touch Chassis Display has a power status light and video
controls located on the side of the display.
Before testing your touch display, make sure all cables are connected properly. Be sure to
tighten all cable screws. After connection, turn on the power switch located on the back
of the display.
To test that the display is working properly:
1. Turn on your computer.
3M Touch Systems, Inc. Proprietary Information – TSD-45335
Remote
OSD
OUT
USB
Touch
3M™ Multi-Touch Chassis Display User Guide
RS-232
HDMI Port
IN
Display
Port
VGA
Port
DVI Port
Audio