Mounting Cal Loudspeakers - Meyer Sound CAL Operating Instructions Manual

CHAPTER 6: MOUNTING CAL LOUDSPEAKERS

MOUNTING CAL LOUDSPEAKERS

CAL loudspeakers come preconfigured with its loudspeaker
brackets already installed. After installing the wall mount
plates, install CAL onto the wall, rotate the loudspeaker to
adjust its horizontal coverage, tighten the top and bottom
nuts, and attach the endcaps.
To mount CAL on a wall:
1. Mount the top and bottom wall mount plates on the wall:
■ Mark two holes on the wall for each wall mount plate
using their center mounting holes as a guide.
■ If you are mounting CAL on a wall with wood studs,
locate the wall stud.
■ Orient the wall mount plates with the side slots up and
make sure the top plate (the smaller one) is mounted the
appropriate distance above the lower plate for your CAL
loudspeaker.
Top wall mount plate
Bottom wall mount plate
NOTE: Orient the wall mount plates with the
side slots up.
28
■ Use a level and straight edge to make sure the top and
bottom wall mount plates are vertically aligned.
Ø0.
[ 7.1 mm]
Ø
1.5 [38.1 mm]
1.5 [38.1 mm]
Ø0.
[
Drill pilot holes at the four marked locations. Make sure
■
not to over-drill the pilot holes. The depth and diameter
of the pilot holes should be around 50 percent of the
length and diameter of the fasteners.
NOTE: The center mounting holes for the wall
mount plates are 0.28 inches (7.1 mm) in diam-
eter.
■ If mounting CAL on a concrete or metal wall, install wall
anchors (not included) in the pilot holes. Install the wall
anchors so they are flush with the wall surface.
Secure the wall mount plates to the wall with fasteners
■
(not included) appropriate for the wall material and rated
to hold the weight of the loudspeaker.
CAL 96 weight: 173 lbs (78.5 kg)
CAL 64 weight: 124 lbs (56.2 kg)
CAL 32 weight: 80 lbs (36.3 kg)
NOTE: Weights include top and bottom loud-
speaker brackets, top and bottom endcaps.
28 (x2)
CAL 96: 115.2 [2926 mm]
CAL 64: 81.8 [2078 mm]
CAL 32: 48.4 [1229 mm]
28 (x2)
7.1 mm]
Ø