Additional Information; Troubleshooting; Additional Information Troubleshooting - Pioneer AVH-X5600BT Operation Manual

Appendix

Additional information

Troubleshooting

Symptoms are written in bold and causes in
regular, non-indented text. Regular, indented
text is used to indicate actions to be taken.
Common
The power will not turn on.
The unit will not operate.
Leads and connectors are incorrectly connected.
Confirm once more that all connections are
correct.
The fuse is blown.
Rectify the cause and then replace the fuse. Be
sure to install a fuse with the same rating.
Noise and/or other factors are causing the built-
in microprocessor to operate incorrectly.
Press RESET. (Page 77)
Operation with the remote control is not pos-
sible.
The unit does not operate correctly even
when the appropriate remote control buttons
are pressed.
Battery power is low.
Load a new battery.
Some operations are prohibited with certain
discs.
Try operating with another disc.
Playback is not possible.
The disc is dirty.
Clean the disc.
The type of disc loaded cannot be played on this
unit.
Check the disc type.
The disc loaded is not compatible with this video
system.
Change the disc to one that is compatible with
your video system.
There is no sound.
The volume level will not rise.
Cables are not connected correctly.
Connect the cables correctly.
The unit is performing still, slow motion or frame-
by-frame playback.
There is no sound during still, slow motion or
frame-by-frame playback.
78
En
There is no image displayed.
The parking brake cable is not connected.
Connect the parking brake cable, and apply
the parking brake.
The parking brake is not applied.
Connect the parking brake cable, and apply
the parking brake.
The icon is displayed, and operation is not
possible.
The operation is prohibited for the disc.
This operation is not possible.
The operation is not compatible with the config-
uration of the disc.
This operation is not possible.
The image displayed stops (pauses) and the
unit cannot be operated.
The data could no longer be read during play-
back.
Stop playback once, and start playback again.
There is no sound.
The volume level is low.
The volume level is low.
Adjust the volume level.
The attenuator is on.
Turn the attenuator off.
The sound and video skip.
The unit is not firmly secured.
Firmly secure the unit.
File size and transmission rate are above recom-
mended rates.
Create a DivX file that is within the
recommended size and transmission rate.
The aspect ratio is incorrect and the image is
stretched.
The aspect ratio setting is incorrect for the dis-
play.
Select the appropriate setting for your display.
(Page 59)
The motor sounds when the ignition switch is
turned ON (or is turned to ACC).
The unit is confirming whether or not a disc is
loaded.
This is a normal operation.