Battery Indicator - MZ GmbH CHARLY Operating Instructions Manual

CHARLY OPERATING INSTRUCTIONS

6. Battery indicator

The battery condition indicator on the handlebar
covering shows the amount of energy currently
available from the battery, and it also indicates the
charging mode and any fault in the vehicle network.
The display consists of 8 light-emitting diodes
(LEDs). LEDs 1 to 8 are ON when the battery is
full. The LEDs go out one after the other starting
with LED 8 as the batteries are discharged.
Legende Diode leuchtet nicht
0
LEDs 1 to 8 are ON (100 %)
Batteries are fully charged or new battery pack
is installed *
* The real discharge degree of the batteries will only be shown after several minutes of driving time whenever partially discharged battery
packs have been installed.
2
1
0
LED 1 and LED 2 are flashing
alternately
The driving performance is reduced
considerably when the battery has been
discharged to approximately 15 %.
Stop! Charge batteries. The drive will
switch OFF when you try to drive on.
Diode leuchtet
100%
LED 1 is ON, LED 2 is flashing.
Discharge degree of battery is
approximately 30 %
100%
LED 1 and LED 2 are flashing alternately
Up to 5 minutes after turning the master
switch OFF
Drive switched OFF! Discharge batteries!
Charge the battery pack immediately!
11
Fig. 6: Battery condition indicator
Diode blinkt
2
1
0
2
1
0
ENGLISH
100%
100%