Changing The Gas Supply - Mastercook GCF32SI User Manual

2 / INSTALLING YOUR APPLIANCE

CHANGING THE GAS SUPPLY

•
Warning
Your appliance is sold pre-set for
natural gas.
The injectors required for adapting it to
butane/propane can be found in the plastic
bag containing this guide.
Each time you change the gas supply, you
must complete the following:
— Adapt the gas connection
— Change the injectors
— Adjust the hob connections.
•
Adapt the gas connection : Refer to the
"Gas Connection" section.
•
Change the injectors, proceeding as
follows:
— Remove the pan supports, heads and
covers from all burners.
— Using the wrench provided, unscrew the
injectors located under each crucible and
remove them (Fig. 01).
— Replace with the corresponding gas
injectors, in compliance with the positioning of
the injectors and the table of gas properties at
the end of this section:
— First screw them in manually until the
injector locks into place.
— Apply the wrench to the injector as far as it
will go.
— Draw a line on the burner plate using a
pencil at the place indicated (Fig. 02).
— Turn the wrench clockwise until the line
appears on the other side (Fig. 03).
Warning
Exceeding this limit may damage the
product.
- Reposition the burner heads, burner covers
and pan supports on the hob.
Tip
Each time you change the gas supply,
tick the box corresponding to the new gas
level on the label found in the plastic bag.
Refer to the corresponding "Gas Connection"
section.
Fig. 01
Fig. 02
11
EN
Wrench
Crucible
Injector
Line
Wrench
Line
Wrench