Table of Contents
Advertisement
Locks and Security
2. Press and hold either the 1 or 2
control on the driver's door for five
seconds. (A tone will be heard after
1
1
⁄
seconds when the memory store
2
is done) continue to hold until a
second tone is heard after five
seconds.
3. Within three seconds press
the
on the transmitter.
4. A tone will be heard when the
activation is complete.
5. Repeat this procedure for another transmitter if desired.
Deactivating the memory feature
To deactivate this feature:
1. Press and hold either the 1 or 2 control on the driver's door for five
seconds. (A tone will be heard after 1
⁄
seconds when the memory store
1
2
is done) continue to hold until a second tone is heard after five seconds.
2. Within three seconds press the
on the transmitter.
3. A tone will be heard when the deactivation is complete.
4. Repeat this procedure for another transmitter if desired.
Replacing the battery
The Integrated Keyhead Transmitter (IKT) or Intelligent Access key (IA
key) uses one coin type three-volt lithium battery CR2032 or equivalent.
To replace the battery:
Integrated Keyhead Transmitter
(IKT)
1. Twist a thin coin in the slot near
the key ring to remove the battery
cover.
Note: Do not wipe off any grease on
the battery terminals on the back
surface of the circuit board.
125
2010 MKS (mks)
Owners Guide, 2nd Printing
USA (fus)
Advertisement
Table of Contents
