Epson PP-50BD User Manual page 30

❏ If you print on the matte label type of Epson specified CDs, set Label Type to CD/DVD
Label.
❏ If you print on the matte label type of Epson specified DVDs, set Label Type to CD/DVD
Premium Label.
❏ When using Epson specified discs, only [1] can be selected for Print Mode setting.
❏ Reprinting on the same disc may not improve the print quality.
❏ Be sure to clean the inside of the stacker before using it if there is any dirt.
❏ Please check disc before printing, as the size of the receptor may vary.
❏ Ink may not bond if printed outside the receptor.
❏ If the product is operating, wait for 10 seconds after the operation is finished, and then
turn the power off.
❏ Data may be lost depending on the disc or storing condition; therefore, store important
data on multiple discs. Epson does not guarantee the data against loss.
❏ Do not insert an object like a screwdriver or clip into the drive slot as this may cause a
malfunction.
❏ A published CD/DVD/BD may not be readable on another type of drive or player due to
compatibility.
❏ The quality of the blank disc determines print and write/read quality. It is recommended
to use only the specified disc type.
❏ It is recommended that you run a compare while writing data.
❏ Making a backup is recommended if the data is important. Recorded data may degrade
over long storing periods. It is recommended to make backups periodically.
❏ Do not shock or vibrate the product while reading or writing, as this may result in
malfunction of the drive or make the disc unusable.
❏ Do not use a cracked, warped, or deformed disc because it may break in pieces inside
the product and cause malfunction or injury.
❏ A disc may become unreadable or unwritable if it has a small scratch or dirt; therefore,
please handle it with care.
❏ Hold disc by the edge, and do not touch either surface.
30
Publishing Discs