Boss BV9386NV User Manual page 9

Tasks
Start using iGO8
When iGO8 is started the first time, you need to do the following:
1. Select the written language of the application interface. Later you can change it in Settings
(page 73).
2. Select the language and speaker used for voice guidance messages. Later you can change it
in Settings (page 73).
3. Read and accept the End User Licence Agreement (page 81).
4. Select whether to start the program in Simple mode or in Advanced mode. Later you can
switch between the two operating modes in Settings.
After this, the Navigation menu appears and you can start using iGO8.
The Navigation menu in Simple mode:
The Navigation menu in Advanced mode:
The typical way of using iGO8 is to select a destination, and start navigating. You can select your
destination in the following ways (not all of them are available in Simple mode):
Use the selected location on the map (the Cursor) (page 29).
Enter a full address or a part of an address, for example a street name without a house number
or the names of two intersecting streets (page 30).
Enter an address with postal code (page 35). This way you do not need to select the name of
the settlement and the search for street names might be faster as well.
Use a coordinate (page 39)
Use a saved location:
a Favourite (page 37)
a POI (page 37)
the History of previously set destinations and waypoints (page 39)
right corner to the bottom left corner on any screen.
Shortcut to open the Navigation menu: slide your finger from the top
left corner to the bottom left corner on any screen.
Instructions
9