Program Timer Operation Procedure; Present Time Setting Procedure - Mitsubishi SRK63ZE-S1 User Manual

PROGRAM TIMER operation procedure

I The timer operations that consist of the combination of the timer being set at both on and off. Once this has been set and operations started,
operations will commence and end at the same time every day as long as the ON/OFF button is not pressed.
About Amenity facilities
Amenity facilities enable to start the operation a little earlier, so that the room
should approach optimum temperature at ON time when the operation is
started by ON-TIMER.
• Mechanism
The room temperature is checked
60 minutes before the timer is at
ON. Depending on the tempera-
ture at that time, the operation
starts 5 to 60 minutes before the
timer is at ON.
• The Amenity facility only func-
tions for COOL and HEAT op-
eration mode (including AUTO).
It does not work for DRY mode.

Present time setting procedure

I When inserting the batteries, the present time is automatically set to 13:00.
In COOL operation
(Stop) Operation starts
(Operation)
Set temperature
Check the room Set time
temp. 60 mins.
in advance.
1
2
3
The timer operation is set on the basis of the present time, so please set it correctly.
Example: When it is desired to stop at 22:30, and then start operation at 8:00, near the set
temperature.
I OFF TIMER operation setting
Set by the procedures on page 11.
I ON TIMER operation setting
Set by the procedures on page 12.
The setting of the lighting of the timer light (yellow) of this unit is complete.
The time will be displayed on the remote control unit. The display will change
depending on the operational status.
(Stopped)
Changing of set time
Set a new time by using the OFF TIMER or ON TIMER button.
Releasing procedure
Press the CANCEL button to turn off the timer indicator.
About SLEEP operation
When SLEEP operation is selected, the room temperature is automatically
controlled after a while, ensuring that the room is not too cold during cooling
or too warm during heating.
• During COOL : the preset temperature is lowered by 1°C at the start of
SLEEP operation (when the timer is set). After that, the temperature goes
up by 1°C every an hour to become 2°C higher.
• During heating: Preset temperature is lowered by 1°C at the start of SLEEP
operation (when the timer is set). After that the temperature is lowered by
1°C every 30 minutes to become 3°C lower in an hour and 6°C lower in two
hours.
Example: Set to 10:30.
Press the TIME SET UP switch.
Press with the tip of a ballpoint pen, etc.
The time indicator blinks and can be set to the current time.
Press the " or " button.
(Set to 10:30)
Press the TIME SET UP switch.
The indication changes from blinking to steady lighting and the setting is complete.
NOTE
– 13 –
Set to
Set to
(Operating)
Press within
60 sec.!