La-Z-Boy Spas Premier Owner's Manual page 18

OPERATIONAL CHECKS
Do not turn on any pump until your spa is properly filled with
water. Running any pump without water in your spa can cause
IMMEDIATE damage, which is not covered by the guarantee!
By now you have rechecked your spa / hot tub mechanical connections and filled it
with water through the pre-filter (if equipped). Turn on power to the spa / hot tub at the
main breaker panel and test the operation of the electrical system. If you encounter a
problem, please reference the troubleshooting guide on page 42.
If this breaker does not trip, immediately call your electrician.
Do not use your spa / hot tub!
INITIAL START UP PROCEDURE
1. Turn on the breaker and test the operation of the Ground-Fault Circuit Interrupter
(GFCI) breaker by pushing the small button. This should automatically trip the spa /
hot tub circuit breaker. Only if pushing this button successfully trips this circuit
breaker should you reset this breaker and proceed to the next step.
2. Go to the topside control panel and look at
the display. The system goes through a brief
startup sequence after which Pump 1 starts
in filtration mode and the panel displays the
current water temperature.
3. Press the Pump 1 button
pump turn on a higher speed, see water circulating in the spa, see the icon swirl on
the display, and see CO in the AquaFlex Massage Control (see page 31).
For HELP, call La-Z-Boy
CAUTION
DANGER
. You should hear the first AquaFlex Massage
Spas at 1.800.465.2933.
®
Figure 8 – Topside Control Panel
18