Remove The Brackets Used For Transport; Routing The Tubing - Sanyo R410A Installation Instructions Manual

3-3. Remove the Brackets Used for Transport

●
After installing the unit, remove the
2 transport brackets from the front
and rear (4 brackets total).

3-4. Routing the Tubing

●
The tubing can be routed out either from the front or from the bottom. (Fig. 3-6)
●
The connecting valve is contained inside the unit. Therefore, remove the front panel. (Fig. 3-6)
(1) If the tubing is routed out from the front, use cutting pliers or a similar tool to cut out the tubing outlet slit (part
indicated by ) from the tubing cover. (Figs. 3-6 and 3-7)
(2) If the tubing is routed out from the bottom, remove
the slit part ( ).
●
Use a drill bit approximately 13/64" dia. to create
holes at the 4 slit hole indentations (openings).
●
Punch out the slit part (
●
Be careful not to damage the base plate.
(Fig. 3-5)
Remove the 2 screws
(8 screws total)
Front
Bottom
Tubing cover
Remove 2 screws
).
Fig. 3-5
Remove 11 panel
screws from front
panel
Use cutting pliers or similar
tool to cut cover out
Fig. 3-6
Indentation
(4 locations)
25
Remove the 2 transport brackets from
the front and rear (4 brackets total)
Slit hole
Fig. 3-7