Cub Cadet RT 65 Operator's Manual page 7

Handle
1. Remove the top two bolts and flange lock nuts from the
handle mounting brackets, but do not remove the bottom
bolt and nut. See Fig. 3-2.
Bolts
Handle
Bracket
Figure 3-
2. Place the handle assembly in position between the handle
mounting brackets.
3. Line up the holes in the handle with the holes in the
bracket and secure it with hardware previously removed.
Clutch Cable
Attach the clutch cable to the handle as follows: (be careful not
to kink the cable)
1. Remove the threaded eyebolt and nut from the cable end.
2. Route the clutch cable to the right side of the handle
mounting brackets and underneath the handle.
3. Push the cable through the hole in the center of the handle
Handle
and snap into the plastic fitting. See Fig. 3-3.
Assembly
4. Remove the slot head screw, nut, and two flat washers
from the clutch bail. See Fig. 3-4.
Clutch Control
Plastic Fitting
Internally
Threaded Tube
Slot-Head
Screw, Nut
& Flat Washers
Figure 3-3
Slot Head Screw
Flat Washers
Nut
Threaded
Eyebolt
Nut
Internally
Threaded
Tube
Figure 3-4
s 2 — a & s
ectiOn sseMbly et
-u 
p