Maintenance; Filter Bag - Royal Lexon S18 Owner's Manual

4. MAINTENANCE

Familiarize yourself with these home maintenance tasks as proper use and care of your vacuum will ensure
continued cleaning effectiveness.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water,
take it to a sevice center prior to continuing use.
NOTICE
!
A Thermal Protector has been designed into your cleaner to protect it from overheating. When the
thermal protector activates the cleaner will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Check fullness of bag, change if needed.
3. Inspect the nozzle inlet, nozzle connector, hose connector, hose, wands, secondary filter, and
final filter for any obstructions. Clear obstructions if present.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate
and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner
needs servicing.

FILTER BAG

When to Replace
4.1 Check the bag when the Sytem Check Indicator
(A) shows red. When bag is filled with dirt, the
cleaner will not operate efficiently. Discard used bag.
CAUTION
! !
Very fine materials, such as face powder or
cornstarch may seal the filter bag and cause it
to burst even though it is only partially full of dirt.
When using the cleaner to remove material of
this nature, change the bag often.
What to Buy: Filter Bag
In order to maintain the original cleaning
effectiveness and superior filtration qualities of your
cleaner, use only Genuine Royal
HEPA Filtration
®
Type S disposable filter bags (package number
AR10130).
How to Replace
WARNING
! !
To reduce the risk of personal injury - Unplug
before cleaning or servicing. Do not use
cleaner without filter bag in place.
4.2 Disconnect hose from the cleaner, pressing the
button (B) on the hose connector and pulling
straight out.
4.3 Open the filter bag door by lifting up on latch (C).
4.4 Pull up on the filter bag frame (D) and remove
from bag compartment.
4.5 Press new bag into collar in the direction
!
4.1
A
4.2
4.3
C
B
4.4 4.5
D
indicated by arrows.
Discard used bag. Be careful not to dispose of filter
bag frame.
Close the bag compartment door and reattach hose.
Actual model may vary from images shown.
9