Troubleshooting; Service - Royal Lexon S18 Owner's Manual

Operating and servicing instructions
Table of Contents

Advertisement

Available languages

Available languages

5. TROUBLESHOOTING

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water,
take it to a sevice center prior to continuing use.
WARNING
!
To reduce the risk of personal injury – Unplug before cleaning or servicing.
PROBLEM
POSSIBLE CAUSE
Not firmly plugged in
Cleaner won't
run
No voltage in wall plug
Blown fuse/tripped breaker
Filter bag full.
Cleaner suction
Obstruction in nozzle
low
connector, hose or wands.
Secondary filter dirty.
Power set too low.
Hose not properly connected
to cleaner
Power nozzle switch "OFF".
Low cleaner suction.
Nozzle won't
Blockage in nozzle connector. Remove blockage.
pick up
Brushroll not running.
Brushroll brushes worn.

6. SERVICE

ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED
SERVICE REPRESENTATIVE
TO LOCATE A DEALER NEAR YOU , VISIT OUR WEBSITE AT
WWW.ROYALVACUUMS.COM OR CALL CUSTOMER SERVICE AT (1-800-321-1134)
In the event that further assistance is required, see your Yellow Pages for an Authorized Royal
Costs of any transportation to and from any place of repair are to be paid by the owner. The service parts
used in this unit are easily replaced and readily available from an Authorized Royal
Always identify your cleaner by the model number and manufacturing code when requesting information or
ordering replacement parts. The model number appears on the bottom of the cleaner.
!
POSSIBLE SOLUTION
Plug unit in firmly.
Check fuse or breaker in home.
Replace fuse/reset breaker in home.
Replace filter bag.
Remove obstruction.
Clean filter with water, allow to dry and
replace in cleaner.
Increase power setting by pushing suction
control slide switch toward MAX.
Ensure hose is properly connected.
Turn switch to "ON" position.
See section "Cleaner suction low".
See section "Agitator brush roll won't run".
Replace brushes.
®
Dealer or retailer.
®
12
Dealer.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents