Brother DCP-585CW Quick Setup Manual page 22

Wired Network
For Wired Network Interface Users (For Mac OS
11
Before you install
a
Make sure your machine is connected to the
power and your Macintosh
be logged on with Administrator rights.
Important
®
• For Mac OS X 10.2.0 to 10.2.3 users,
upgrade to Mac OS
the latest information for Mac OS
http://solutions.brother.com/)
• Make sure there are no memory cards or a
USB Flash memory drive inserted.
• If you have previously set up your machine
for a wireless network and then want to set
it up on a wired network, you should check
that the machine's Network I/F is set to
Wired LAN. The wireless network interface
will be inactive with this setting. On your
machine, press Menu.
Press a or b to choose Network and press
OK.
Press a or b to choose Network I/F and
press OK.
Press a or b to choose Wired LAN and press
OK.
Press Stop/Exit.
12
Connect the network
cable
a
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
22
®
is ON. You must
®
X 10.2.4 or greater. (For
®
X, visit
Macintosh
®
X 10.2.4 or greater)
b
Connect the network cable to the LAN socket
marked with a
LAN socket inside the machine on the left as
shown below.
LAN USB
c
Carefully guide the network cable to the trench
as shown below, following the trench around
and toward the back of the machine. Then,
connect the cable to your network.
Important
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
Note
If both USB and LAN cables are being used,
guide both cables through the trench with one on
top of the other.
d
Lift the scanner cover to release the lock a.
Gently push the scanner cover support
down and close the scanner cover c.
b
2
®
symbol. You will find the
1
3