Web Interface Conventions; Web Interface Administration Privileges - Linksys SPA941 Administration Manual

Web Interface Conventions

The SPA uses the following conventions with the web administration capabilities:
•
The SPA web administration supports two privilege levels: Administrator and User. To use the
User privilege, simply point a web browser at the IP address of the SPA; to use the administrator
privilege, use URL http://<IP_Address_Of_SPA>/admin/.
•
Version 1.0 of the SPA supports Internet Explorer 5.5 and above and Netscape 7.0 and above.
•
The web configuration pages can be password protected. See 0 for more information about
password protect.
The user name of web Administrator is : admin
The user name of web User is : user
Note: The user names for both administrator and User are fixed and cannot be changed.
After making changes to SPA configuration parameters, pressing "Submit All Changes" button will apply
all the changes and if necessary, automatically reboot the device. Multiple changes may be made on
multiple page tabs of the web interface at the same time. Pressing "Submit All Changes" will apply all
the modifications.
Important Note: switching between page tabs won't apply the changes to SPA, The only way to apply
the changes is to press the "Submit All Changes" button.
If the "Undo All Changes" button is clicked, any modifications to profile parameters on any and all pages
will be reset back to their original values before modification.
NOTE: Pressing the "Undo All Changes" has no effect on the SPA; it will only reset the values on the
web page.

Web Interface Administration Privileges

The SPA supports two levels of administration privileges: Administrator and User, both privileges can be
password protected. Important note: by factory default, there are no passwords assigned for both
Administrator and User.
The Administrator has the privilege to modify all the web profile parameters and can also modify the
passwords of both Administrator and User. A User only has the privilege to access part of the web profile
parameters; the parameter group that User can access is specified by the Administrator, which can only
be done through provisioning.
To access the Administrator level privilege, use URL: http://IP_Address_Of_SPA/admin/. If the password
has been set for Administrator, the browser will prompt for authentication. The username for Administrator
is "admin" and cannot be changed.
To access the User level privilege, use URL: http://IP_Address_Of_SPA/. If the password has been set
for User, the browser will prompt for User authentication. The username for User is "user" and cannot be
changed.
© 2003 - 2005 Linksys, a Division of Cisco Systems Proprietary (See Copyright Notice on Page 2)
DRAFT
43