Safety Regulations - Ferroli 20-V Installation And Operation Manual

Strictly comply with the following regulations to prevent injuries to the operator or damage to the machine.
·
The machine must be installed in compliance with the laws in force in the country of use.
·
This installation manual, the operating instructions and the wiring diagrams are an integral part of the machine.
They must be kept with care and be ready to hand for consultation when required.
·
Failure to comply with the instructions in this manual and inadequate installation of the conditioner may void the war-
ranty. Moreover, the Manufacturer shall not be liable for any direct and/or indirect damages due to incorrect installa-
tion.
·
All supplementary maintenance operations must be carried out by specialized and authorized personnel.
·
Work in a clean, uncluttered place when installing the appliance.
·
It is absolutely forbidden to touch moving parts or to get between the same.
·
Before starting the conditioner, make sure that the various components and the entire system are in perfect and safe
conditions.
·
Strictly comply with the routine maintenance operations.
·
If parts need changing, insist on genuine spares. Failure to do so will void the warranty.
·
Do not remove or tamper with the safety devices.
·
Disconnect the electric power source before proceeding with any work on the machine.
· The coil surface is sharp. Do not touch it without protective gloves.
·
Carefully read the stickers on the machine. Never cover them. Replace them immediately should they be damaged.
·
Do not use the machine in an explosive atmosphere.
·
The power line must be regularly grounded.
·
If the power cable has been damaged, stop the machine if it is operating, and have the flex immediately replaced
by an authorized electrician.
·
The machine must be stored at a temperature between -25°C and 55°C.
·
Use a powder extinguisher in the event of a fire outbreak. Do not use water.
·
If the power cable has been damaged, stop the machine if it is operating, and have the flex immediately replaced
by an authorized electrician.
·
All supplementary maintenance operations must be carried out by specialized and authorized personnel.
·
The appliance must not be dumped if it is to be scrapped since it contains materials that must be recycled or dispo-
sed of by authorized centers.
·
Do not wash the machine with direct or pressurized jets of water or with corrosive substances.
·
The temperature of the cold water must not be less than 5°C (to prevent condensation from forming). The tempera-
ture of the water must not exceed 70°C. The water must be clean and with a pH between 6.5 and 7.5.
·
When the unit remains at a seasonal standstill, the coils must be filled with water to reduce the risk of oxidation. The
appliance must be protected against freezing temperatures during winter.
The Manufacturer and dealer network are at your disposal and will provide prompt and accurate technical assi-
stance to ensure that your conditioner always operates in the best and most efficient way.
6

SAFETY REGULATIONS