Table of Contents
Advertisement
B
'
P
(
UILDER
S
LATE
DOMESTIC
(F
. 1.6.1)
IG
MAXIMUM CAPACITIES
10
PERSONS OR
1800 POUNDS, PERSONS, GEAR
THIS BOAT COMPLIES WITH U.S. COAST
GUARD SAFETY STANDARDS IN EFFECT ON
THE DATE OF CERTIFICATION
SEA RAY BOATS, INC.
MANUFACTURER:
Phoenix, AZ
MODEL: 220 Select
DESIGN COMPLIANCE WITH NMMA REQUIREMENTS BELOW IS
VERIFIED. MFR. RESPONSIBLE FOR PRODUCTION CONTROL
LOAD AND CAPACITY • COMPARTMENT VENTILATION
STEERING, FUEL AND ELECTRICAL SYSTEMS
INTERNATIONAL LIGHTS • BASIC FLOATION
MANEUVERABILITY
C e r t i f i e d
NATIONAL MARINE MANUFACTURERS ASSN.
N M M A
B
'
P
(
UILDER
S
LATE
INTERNATIONAL
(F
. 1.6.2)
IG
BOAT MANUFACTURER
220 Select
10
C
MAXIMUM NUMBER
OF PASSENGERS
!
DANGER
Never carry more weight or passengers than indicated
on the certification plate, regardless of weather or
water conditions.
The boat can capsize, swamp or sink.
1.6
S
1 • S
ECTION
)
1600
LBS.
)
MFR'S MODEL
DESIGNATION
820
kg.
MAXIMUM LOAD
CAPACITY
AFETY
!
WARNING
When engine is running, keep passengers away from
areas not designed for riding, such as seat backs,
bow, gunwales, transom platform, swim platform,
front and rear decks and on sun pads.
Passengers can fall overboard if not seated properly
on the seats provided.
9. P
C
OWER
APACITY
Do not exceed the maximum engine power rating
stated on the certification plate. Your boat will be
difficult to handle and will be less stable.
®
Your Sea Ray
has been equipped with a propeller
which our tests have shown to be the best suited
for general use with our engine under normal
conditions and load. Do not change the pitch of your
propeller
without
recommendations first. If you change to a different
propeller pitch, under no circumstances use a
propeller which allows the engine to operate at
higher than recommended RPM. (your engine
manual specifies the maximum recommended
(RPM).
To maintain rated power, propellers should be free
of nicks, excessive pitting and any distortions that
alter them from their original design. Badly damaged
propellers should be replaced, but those that are
chipped, bent or merely out of shape can be
reconditioned by your marine dealer.
It is advisable to carry an extra propeller aboard in
case you damage the one in use.
10. S
TABILITY
Your boat was manufactured to specific stability and
flotation standards for the capacity shown on the
cer tification plate. Any increase from the
recommended load capacities will put your boat in
jeopardy of capsizing, swamping and/or sinking.
getting
your
dealer's
220 Select
Advertisement
Table of Contents
