Storing The Housing; Spare Parts; Photo Tips - Ikelite 6801.52 Instruction Manual

Storing the Housing

When the housing is going to be stored for a prolonged period it should
be soaked in a mild soap solution, rinsed and thoroughly dried. Remove
the back and port from the housing. Remove the back and port o-rings,
lightly lubricate them, and then place them in a plastic ziploc or
resealable plastic bag. Place the plastic bag inside the housing for
storage. Operate the push buttons periodically

Spare Parts

0132.59 ..........Spare Main Housing O-ring
0105................Spare Port-to-Housing O-ring
5020................Silicone Lubricant in 4 1cc Tubes
5512.68 ..........O-ring Kit with Main O-ring, Port O-ring, & 1cc Lubricant
0333.6 ............Tray Mounting Screw 12-24 x 1/2 in. Stainless
0212.12 ..........1/4 in. Shoulder Washer for 12-24 Screw
9104.5 ............Waterproof Bulkhead Cap
0200.91 ..........Body Cap

Photo Tips

- The number one rule in underwater photography is to eliminate as much
water between the camera and subject as possible. Get as close as you
can to the subject, then use the zoom. If you are using flash for still
photos, subjects beyond 6 feet (1.8m) will not have much color
regardless of strobe power.
- Photograph in clear water; do not stir up the sand or silty bottom. If
backscatter becomes a problem in the environment you are
photographing, an external flash will help eliminate much of the
backscatter.
.
29