Table of Contents
Advertisement
Storing the Housing
When the housing is going to be stored for a prolonged period it should
be soaked in a non-abrasive mild soap solution such as dish soap,
rinsed, and then thoroughly dried. Remove the back and port from the
housing. Remove the back and port o-rings, lightly lubricate them, and
then place them in a plastic ziploc or resealable plastic bag. Place the
plastic bag inside the housing for storage. Operate the push buttons
.
periodically
Spare Parts
0132.61 ..........Spare Main Housing O-ring
0105................Spare Port-to-Housing O-ring
0184.2 ............Silicone Lubricant 2cc Reclosable Tube
5512.69 ..........O-ring Kit with Main O-ring, Port O-ring, & 1cc Lubricant
0333.6 ............Tray Mounting Screw 12-24 x 1/2 in. Stainless
0212.12 ..........1/4 in. Shoulder Washer for 12-24 Screw
9104.5 ............Waterproof Bulkhead Cap
0200.91 ..........Housing Body Cap
Photo Tips
-
The number one rule in underwater photography is to eliminate as much
water between the camera and subject as possible. Get as close as you
can to the subject, then use the zoom. If you are using flash for still
photos, subjects beyond 6 ft (1.8 m) will not have much color regardless
of strobe power.
-
Photograph in clear water; do not stir up the sand or silty bottom. If
backscatter becomes a problem in the environment you are
photographing, an external flash will help eliminate much of the
backscatter.
29
Advertisement
Table of Contents
