Description; Features - Omnitronic SMA SERIES User Manual

shocks. When using smoke machines, make sure that the device is never exposed to the direct smoke jet
and is installed in a distance of 0.5 meters between smoke machine and device.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
The ambient contamination must never exceed level 1 and must not be conducting, only dry.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Never remove the serial barcode from the device as this would make the guarantee void.
Please consider that unauthorized modifications on the speaker system are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, hearing loss etc.

5 DESCRIPTION

5.1 Features

Stereo PA amplifier with integrated limiter and SMPS
• Low weight and height due to integrated switch-mode power supply
• Temperature-controlled fan, particularly quiet during operation
• Limiter and speaker switch-on delay
• Peak filter at 80 Hz with 6 dB level increase
• 3 operating modes can be selected (stereo, parallel or bridged)
• Selectable input sensitivity
• 2 level controls
• 3 LEDs for each channel for activated protective circuit (protect) overload (clip) and signal
• 2 LEDs for parallel and bridge operation
• Complete protection set against short-circuit, overheat, DC voltage and VHF signals
• Electronically balanced inputs via XLR mounting jacks, with feed-through output (stereo RCA/6.3 mm jack)
• Speaker outputs via lockable Speaker plugs
• SMA-360, SMA-600, SMA-100 with class AB circuitry; SMA-1500, SMA-2000 with class 2 H circuitry
• SMA-1500 and SMA-2000 with additional pairs of screw terminals for 8 ohms bridge operation
• Robust steel chassis
• 19" dimensions with 2 units
26/36 00043972.DOC, Version 1.2