Installing the Hardware
The steps below show you how to connect an InfoWave unit to a computer.
1. Power off the computer.
2. Take one serial cable out of the InfoWave kit. Connect one end of the serial cable to
the 9-pin male communications (COM) port on your computer. If your computer has
a 25-pin COM port, use the 9-to-25-pin adapter included in the package.
3. Connect the other end of the serial port to the 9-pin female COM port on the back of
the InfoWave unit.
4. Plug the power supply pack into the +5V DC power input in the back of your
InfoWave unit.
Hardware installation is now completed on one computer. Remember to perform the
entire procedure for the other computer to be networked. The following picture shows the
detailed information about how to complete the hardware installation.
Using the Power Adapter Cables
One PS/2 power adapter cable is included in the InfoWave kit. The power adapter cable
allows you to power up the InfoWave unit from a desktop or notebook PC instead of
using the AC/DC power adapter. To use the cable, do the following:
1. Connect one end to the InfoWave DC power supply, and connect the other end of the
cable to a PS/2 pass-through connector.
The InnoMedia Wireless Group
http://www.innomedia.com/wireless/
9